Double Edge Milling Cutter Ball Nose End Mills

  • Sale
  • Regular price $14.99
  • Will be in stock after

 Double Edge Milling Cutter  Engraving Bits Ball Nose End Mills Tool

Type:2 flute noze end mills
End design:ball nose
Shank diameter:3.175mm
Cutting edge diameter: 2mm/0.08"
Cutting edge length: 17mm/0.67"
Total length:approximately 39mm/1.53"


-Non stick knife, tasteless, quiet, blade design, sharp
-Clean, tidy, no burr
-Spiral chip design, chip smooth, reduce heat
-Applies to the relief process of sub GREE, PVC, density board, hard wood

1.For the design of portable and desktop woodworking engraving
machine, can not be used in drill machine.
2. Smooth surfaces, such as wood, to avoid the processing of copper,
iron and other metal and sand, stone and other non wood materials.
3. Use appropriate size clip.
4. Tool clamping, found that the knife has a beating phenomenon, should
immediately stop, repeat clip a few times to get the tool shank and fixture
to get full contact, and then work.
5 Cutter handle and the clamping sleeve contact should be good, a tool
shank must be fully inserted into the jacket, tighten firmly.